• Welcome to this forum . We are a worldwide group with a common interest in Birmingham and its history. While here, please follow a few simple rules. We ask that you respect other members, thank those who have helped you and please keep your contributions on-topic with the thread.

    We do hope you enjoy your visit. BHF Admin Team

Radio: Crystal Sets & CB Radio

  • Thread starter Thread starter O.C.
  • Start date Start date
Revo11.jpg

When The Light Programme (Radio 4) started broadcasting on 29th July 1945, on 1,500 metres, in the Long Wave band, Revo produced a dual band version of the 'Revophone' using a plug-in Long Wave coil.
Revo8.jpg

The instructions read as follows:

Fixing. Erect the aerial as shown above seeing that the down lead is a foot away from the building. A hole should be bored through the window frame to receive the window terminal. Use the flexible insulated wire to connect from the window terminal to terminal marked “A” on the receiver, and the insulated single wire should be used from terminal marked “E” to the nearest water pipe, an adjustable clip is provided for this purpose.

Using. The headphones should be connected to terminals marked “P” and both tuning switches placed in the central position. Now operate the adjusting knob on the crystal detector so that the spring bears gently on the crystal. If broadcasting is in progress a sound will be heard in the phones on turning the coarse tuning switch to the right or left, the final adjustment being made on the fine tuning switch; the best position for the switch arms can easily be found by trial. To obtain the best results a little practice is necessary in adjusting the detector spring.

Several headphones can be used if desired, but they should be of the same kind to give the best results. If any difficulty is experienced with this set, the manufacturers will give advice free of charge on request.

source historywebsite.co.uk
 
Hi,

The first time I came across the 'Foxhole Radio' was in the early 60s, when I was shown a
circuit by a guy at Norman Field's in Hurst Street. He insisted it should be a rusty blade, or
one of those with an anodised finish. Also the tickler was to be a pencil lead rather than a pin.

Of course, none of the 'improvised diodes' work as well as a good old germanium diode.
Apparently the 1N34 diode is the favourite.

Kind regards
Dave
 
when the old telephone exchanges were demolished i sorted through the bits looking for swag to make x radios , later on i added a one transistor amp to use a speaker

:grinning:
A 1N34 germanium diode.
This diode can handle a reverse DC voltage Of 20V.
And the diode can handle a forward current of 150mA and a peak surge current of 500mA.
Its pinout is shown below.

Germanium diode pinout
 
You must log in or register to reply here.
Back
Top